Sentence examples for thickness of bulk from inspiring English sources
where d is length the of a SiNW, W is the thickness of bulk silicon, τSiNW is the lifetime of a SiNW, and τBulk is the lifetime of bulk silicon.
The detailed device parameters in the simulations are as follows: the thickness of bulk silicon (T si) is 20 nm; the lengths of Gate1 (Lg1) and Gate2 (Lg2) are 400 nm and 200 nm, respectively; the length of gap (L gap) between Gate1 and Gate2 is 50 nm; the thickness of gate oxide (HfO2) (T oxide) is 3 nm.
The system size along the Z-axis is determined by specifying the thickness of bulk water from the protein extent along the Z-axis, as shown in Fig. 3.
Based on the Mt. Hagen tephra deposition experiment, compaction occurs rapidly after deposition, primarily, we suspect, as a result of raindrop impact; records of tephra thickness (and of bulk density) may be quite dependent on how long after deposition measurements were made.
The response functions are thickness of flake, bulk density, puncture force, colour parameters and the sensory overall acceptability.
Using depth profiling and X-ray photoelectron spectroscopy on the resulting fracture surfaces, we examine the gradient of molecular components through the thickness of the bulk heterojunction layer.
A larger reduction in particulates size was observed after thermal treatment compared with the reduction in thickness of the bulk coating.
The thickness of the bulk grafted materials was a few nanometers after 30 s irradiation, and possibly, the grafting density was much higher and the grafted polymers were much less branched than those produced in solvent.
Details on etchant composition and etch durations used, method for determining the thickness of etched bulk Si, visual appearance of Si samples after etching, SEM images of SiNWs fabricated using high HF H2O2 molar ratios, graphs of SiNW etch rates versus time, and additional TEM images of SiNWs showing varied porosity.
The thickness of each HTS bulk is 5 mm, and the gap lengths from 0 mm to 10 mm were used as parameters in analysis and experiment, respectively.
A previous study reported that this internal stress as well as the plastic flow of PE increased with a decrease in the thickness of the PE bulk [ 19].
