The coating thickness is increased with the treatment time increasing.
If we use the maximum absorbance value with the literature molar absorptivity at 3404 cm−1, the calculated sheet thickness is increased only slightly to 17 ± 2 nm.
Compared to QWIPs, the emitter layer thickness is increased to avoid confinement.
As chip thickness is increased, the fixed point becomes unstable via a sub-critical Hopf bifurcation.
The chatter amplitude increases and then decreases when the cutting velocity or the uncut chip thickness is increased.
We generated a knockin mouse model and find that, as in humans, hair thickness is increased in EDAR370A mice.
Interestingly, SE is further raised up to 52.5 dB when the film thickness is increased to 10 mm.
Compared to PEI adsorbed from clean water the thickness is increased by a factor three to four.
When the film thickness is increased, i.e. the substrate strain is relaxed; the ESM region in the phase diagram shrinks, confirming the influence of strain on the ESM.
The conversion efficiency of the prepared films increased from 0.23%to3.1%1% when the thickness is increased from 14 nm to 157 nm.
The average current density decreases by 14.6% if the hydrogen channel diameter is narrowed by 50%, and by 10.2% if the support thickness is increased by 50%.
