Sentence examples for thickness expanded from inspiring English sources

Upon heating to 60 °C, the FLG thickness expanded to 13.8 Å, which further increased to 14.3 Å upon cooling to 25 °C.

According to atomic-force microscopy (AFM) measurements of the thicknesses of Pt layers before and after selenization, it has been found that the initial Pt thickness expands approximately four times after selenization.

The results show that the optimum thickness of extruded polystyrene (XPS) is between 0.053 and 0.069m and the optimum thickness of expanded polystyrene (EPS) is between 0.081 and 0.105m.

As seen in Fig. 4, the thickness of expanded austenitic layer in the UPN is about 12 µm, while in the DPN is about 20 µm.

The embryos were sectioned (10 μm thickness) and expanded in the water bath (Section Transfer System; Thermo, MA, USA).

When an electric voltage is applied across the thickness of a thin layer of an dielectric elastomer, the layer reduces its thickness and expands its area.

The thickness of the expanded austenite layer was derived afterwards from glow-discharge optical spectroscopy.

This sticking and slipping of one part against the other is known as stick slip and results in fluctuation in the force required for expansion as well as unexpected changes in length and thickness of the expanded tubular.

With increasing N2 percentage from 15%to35%5% at 380 °C, the thickness of the expanded martensite (α′N) layer increases to about 20 μm and surface hardness also increases to about 1280 HV0.05 but the corrosion behavior is worse than the untreated sample.

DA 2 is loaded more equally on all parameters than DA 1, but slightly stronger on relative cortical thickness for the classification expanded from Viscor et al.21, and slightly stronger on mass-normalised torsional resistance for the classification expanded from Close et al.20.20

Note that conductivity in the 3D array was higher than that in the 2D array, even though the total thickness of the QDSL expanded.