Sentence examples for theoretical insertion from inspiring English sources

Insertion efficiency is defined as the actual channel number per vesicle determined by FCS divided by the theoretical insertion number, for which we assumed all PAP channels added to the reconstitution mixture were embedded into the vesicle bilayers (Fig. 2f, see Supplementary Methods).

The theoretical insertion loss (dB) vs coupling (dB) for a dissipationless coupler is shown in the graph of figure 3 and the table below.

2) Genes found to have an actual to theoretical insertion ratio of 50-fold or greater under-insertion were considered putatively essential (actual:theoretical ≤ 0.020).

By designing an absorptive top screen using the theoretical models, an insertion loss of 17 dB at a frequency of 500 Hz, 20 dB, at a frequency of 1000 Hz and 25 dB and at frequency of 2000 Hz could be obtained.

Consistent with theoretical predictions, the insertion of Bax-type proteins into a planar lipid increases the monolayer curvature, forming a large protein-lipid pore (Basañez et al., 1999, 2002).

In this regard, our method still shares some affinity with methods that make assumptions of transposition selection balance (Charlesworth and Langley 1989; Petrov et al. 2003), since it generates an expected frequency in the population based on a theoretical distribution of insertion ages, not precisely known ages.

From a theoretical point of view, insertion of an insulator or an enhancer blocker at a random site in the genome is a double edged sword since on one hand it should minimize activation of flanking genes by enhancers present in the transgene, but on the other hand, it might perturb expression of the flanking genes by interrupting communication between endogenous regulatory sequences.

Theoretical calculations have indicated that insertion of O monolayers into Si lattice creates anisotropy in the Si band structure with an enhanced carrier mobility in the channel direction.

This paper reports a theoretical and experimental study of insertion loss of stiffened enclosure plates which are used for noise control in industrial machines, automobiles, trains and aircrafts.

This paper describes a theoretical acoustical model to predict insertion loss and radiated sound pressure level, in which the source impedance is obtained from measurement (see the accompanying paper) and from which the source strength is estimated.

The first discharge and charge capacities are both around 250 mA h g−1 (Fig. 8a), which is close to the theoretical capacity for two Li insertion into V2O5 (290 mA h g−1) [4].