Figure 6a shows the voltage at the grid access point when the voltage unbalance factor of the grid simulator was set to 7.5 %. Figure 6b shows the grid simulator output voltage.
To determine the diastolic pressure, we record the DC value at the point when the amplitude of the oscillation decreases to below the threshold voltage.
In Fig. 4, the point marked with "A" is the equilibrium point when no voltage is applied, while the point marked with "B" is equilibrium point under high voltage.
In this research, the reset voltage is defined as the point when obvious current drop exhibits and sometimes even accompanied with unstable I-V properties.
This means that although voltage can be used to bring the resistance down initially, there will come a point when the resistance is low enough such that small voltage step increases can cause nanowire damage, particularly when the breakdown voltage requirements are reached which is the point where a sharp decrease in resistance occurs.
That is, when the subject breathes in, the voltage is high, when the subject breathes out, the voltage is low.
To estimate the conditioning voltage when the subsequent peak Na+ current is half maximally inactivated, the data points can be fitted to the equation: (1) Here h∞ is the relative Na+ current, Vh is the voltage when the Na+ channels are half maximally inactivated (h∞ = 0.5) and kh is the steepness coefficient.
The accelerometer data are digitized voltage "points" around a baseline voltage present when the Wiimote is at rest.
When the voltage at the point of common coupling is fluctuant, the embedded IG will show the impedance characteristic with dynamic changes under the different fluctuation frequencies.
Then, discharge courses are modelled and simulated using Wiener processes to obtain a set of time points when the battery voltage drops below a critical value.
Figure 4 shows the simulation voltage wave when the grid simulator outputs a voltage frequency of which is 62 Hz; the dotted line is the output voltage of the grid simulator, and the solid line is the voltage wave at the grid access point.
