Sentence examples similar to the value of insertion from inspiring English sources

Since the average value of insertion torque in this study was 32.7 ± 9.2 N cm, it was inferred that this study evaluated implant treatment for relatively soft bone quality.

The aim of this study was to measure and correlate the values of maximum insertion and removal torques of miniscrews in artificial posterior maxilla and posterior mandible.

In addition, the screw dislocation in the test blocks can affect the value of pull-out force during insertion.

We confined ourselves to small deletions and insertions because while the length of deletion and insertion increases, the value of function F decreases [see Equation (6)].

As similar to the previous process, insertion length with the value of 400 and coverage cutoff with the value of 2 were used for OASES 0.2.28 run.

For example, when T7 DNA pol encounters a correct dNTP, the value of k3 is much greater than the value of k 2, which leads to rapid nucleotide insertion.

Under this condition it is sufficient to extract (Q_{mathrm{l}}) for each mode n from biglvert S_{21}(nu) bigrvert =frac{S^{mathrm{max}}_{mathrm{n}} }{sqrt{1+4 nu/nu_{mathrm {n}}-1)^{2} {Q_{mathrm{l}}}^{2}}}+C_{1}+C_{2} nu (1) neglecting the specific value of the insertion loss ((S_{mathrm{n}}^{mathrm {max}}) is a free scaling factor).

Until more insertions of IPPI are isolated, however, and expression data are available from a number of IPPI and PP insertions, we can only speculate about the effectiveness of the insulators and the possible value of PP insertions for assessing cis-acting elements in flanking chromosomal regions.

A sound absorbent median noise barrier 1m in height produced consistent values of insertion loss of between 1 and 2dB over the range of receiver positions and ground conditions considered.

The high-frequency model yields good agreement between experimental results and predicts accurate values of insertion loss over a greater range of frequencies than expected for the enclosure with the largest free volume.

The highest values of the insertion charge density were observed for films containing TiO2 between 0.05 and 0.5 mol%.