Sentence examples for the table rotation from inspiring English sources

The table rotation is controlled electronically via a photodiode-based system, so that the position of the detectors under the source is known with a maximum uncertainty of 0.5 mm.

The purpose of this paper is to investigate the effect of the diamond grain size, the wheel rotation speed, the table rotation speed, and the applied pressure in the vertical flat grinding on the surface roughness of silicon wafers using Taguchi orthogonal array design.

When the smaller diamond grit size, the faster wheel rotation speed, the faster table rotation speed, and the smaller applied pressure in the flat grinding are employed, the traces produced by the grains are denser and the chip thickness and the depth of cut were smaller, which cause the silicon wafer to produce the higher degree of the ductile grinding.

The intraoperative table rotations for the surgical procedure might slightly affect CVP values.

Students had the opportunity to engage in conversation at the opening reception, two table rotations during the course of the dinner and an informal dessert reception.

However, if possible, try to find events that include more built-in structure, such as table rotations or icebreaker activities.

This study was designed to compare the overall accuracy of frameless with framebased radiosurgery, to evaluate immobilization characteristics (i.e. intrafraction motion) of a frameless mask device to invasive fixation (frame-based technique) and to evaluate if verification images during radiosurgery treatment can correct for mechanical inaccuracy of table rotations and intrafraction motion.

Therefore, CCDP can be used as a basis to infer the extent of hip rotation thus: HR = arcos (tan (γP) / tan (γI)) The Table gives the hip rotation in 5° steps from 0° to 90° relative to the CCDP, and γP for implants with CCDI ranging from 110° to 145°, also in 5° steps.

The oscillators were rotated on a high-precision air-bearing rotation table (Kugler GmbH); an 18,000 point optical encoder was used to track the angular position of the table and maintain a constant rotation velocity.

Three measuring modes are proposed considering the efficiency of the structured-light sensor, the high accuracy and flexibility of the trigger probe and the rotation of the table for finding proper scanning views.

Pressure in the final two cycles of the supine position prior to the rotation of the table is compared with the pressure in the final two cycles of the simulation for both no-control and control cases.