Sentence examples for the specified component from inspiring English sources

The getIfaces method of the LooCI API is supported by a response message containing a two-byte SHORT_ID, one byte component ID, the IPv6 address of the originating node and an array containing the SHORT_ID and GUID of all interfaces of the specified component that match the incoming query event.

Latency was defined as the most positive data point within the specified component timeframe (Early P300 – 250-430 ms) and a 2×2 mixed factorial ANOVA was used to examine the effect of Load (low, high) across Groups (psychotic symptoms group, control).

Although fitting-out operations are diverse and complex, as with hull construction there are four main divisions: (1) collection and grouping of the specified components, (2) installation of components according to schedule, (3) connection of components to appropriate piping and/or wiring systems, and (4) testing of completed systems.

The ICF is a systematic classification, in which the letters (b, s, d and e) refer to the specified components of the classification.

To gain insight into the properties of this estimator, they consider an orthonormal design matrix and focus on the estimation of a specified component of this vector.

First, the structural reliability of a specified component is evaluated considering potentially active degradation mechanisms, including those that are not explicitly addressed in the design codes.

The PREVENT program included the following minimally specified components: (1) dementia care manager (DCM); (2) electronic tracking of patients status; (3) interdisciplinary dementia management resources; (4) collaborative work with the patients' primary care provider; and (5) caregiver support (see Figure 1).

This is chiefly due to the lack of support for specifying component interfaces and software compositions formally.

The get_model_component command returns the parameter values and settings currently defining the specified model component (the get_model function returns the full model by data set ID).

The first two arrays contain the flux with upper and lower bounds for the original model and the specified model component(s), respectively.

The screen output shows the 0.3-7 kenergyrgy flux with upper and lower bounds in units of [ergs/s/cm2], for the full model fit to the data, followed by the flux for the specified model component, p1+kt.