Sentence examples for the specific gravimetric from inspiring English sources

where F = 26.8×103 mAh mol−1 (Faraday constant), x is the charge of electroactive species, [electrolyte] is the molar concentration of electrolyte in M (mol L−1), Cc is the specific gravimetric capacity of the graphite cathode in mAh g−1, ρ is the density of the electrolyte in g ml−1, and ρC is the density of the bulk graphite in g ml−1.

Considering the loading mass of MnO2 is 1.29 mg, the specific gravimetric capacitance is calculated to be 204.3 F/g.

The carbon CS15A6, which was obtained after CO2 treatment for 6 h at 950 °C using CMK-3 as the precursor, showed the best electrochemical behavior with a specific gravimetric capacitance of 223 F/g and volumetric capacitance of 54 F/cm3 at a scan rate of 2 mV/s and 73% retained ratio at 50 mV/s.

A single MnO2/CFs fiber electrode exhibits a specific volumetric capacitance of 58.7 F cm−3 with a specific gravimetric capacitance of 428 F g−1 based on the MnO2 mass.

The electrodes fabricated from 30 Fe3O4/RGO bilayers exhibited excellent capacitive performances with a maximum specific gravimetric capacitance (151 F/g) at a current density of 0.9 A/g.

AC-4 and OAC-3 had a specific gravimetric capacitances of 361.3 and 392.7 F/g at a scan rate of 0.5 mV/s, respectively.

Mn substitution greatly enhances the specific capacitance of the spinel, giving gravimetric and superficial specific capacitances of ca. 110 F g−1 and ca. 380 μF cm−2, respectively for x = 0.5 powder.

Increasing the specific surface area of ACs increases the capacitor gravimetric energy density and power density, but decreases the corresponding volumetric performance.

At 100 mbar CO2 and 298 K the specific uptake of CO2 on Sc2 BDC-NH2 3 was known from gravimetric measurements to be 0.393 mmol g−1.

The gravimetric specific capacitance for the whole supercapacitor cell was calculated from the GCD curve by considering the total mass of the two electrodes.

The gravimetric specific capacitance for the whole supercapacitor cell was calculated from the galvanostatic charge/discharge (GCD) curve by considering the total mass of Co3O4, SGP, and CNT, namely, the mass increase of the Ni foam.