Sentence examples for the solution was withdrawn from inspiring English sources

After the given time interval, 2 mL of the solution was withdrawn from the Pyrex photoreactor and the UV visible absorption spectrum was taken at 554 nm as indicated in the literature [28].

A sample (10 mL) of the solution was withdrawn from the dissolution apparatus at designated intervals, where withdrawn samples were replaced with fresh dissolution medium.

The solution was withdrawn at a flow rate of 5 μL/h, and the fluorescence levels after each stage were measured (mean and SD, n = 3 in different regions).

Controls were prepared containing minimal media and respective dye and synthetic minimal media without dye were taken as blank. 2 mL of the solution was withdrawn from each flask after every 24 h interval up to 15 days.

A sample (5 mL) of the solution was withdrawn from the dissolution apparatus till 6 hours at sampling period of 5, 10, 15, 30, 45, and 60 min and then sampling was followed by every twenty minutes till 360 min.

The mixture was incubated at 25°C for 150 min. An aliquot of 0.5 ml of the solution was withdrawn and mixed with 0.5 mL of Griess reagents [(1.0 ml sulfanilic acid reagent (0.33% in 20% glacial acetic acid at room temperature for 5 min with 1 ml of naphthylethylenediamine dichloride (0.1% w/v)].

The initial pH values of the solutions were previous adjusted to 7. Aliquots of the solution were withdrawn at a predetermined time intervals and were centrifuged at 3500 rpm for 15 min to remove any adsorbent particles.

Thus, for all the adsorption tests presented thereafter, the stirring was continued for 120 min before aliquots of the solutions were withdrawn, centrifuged (236 HK, Hermle, German) for 10 min at 12,000 rpm and 25 °C and subsequently filtered with filter paper (0.45 μm) to remove the adsorbent.

When the DCB-OA mixture reached the targeted temperature, the precursor solution was withdrawn into a syringe (G 20 needle) and injected into the four neck flask within an injection time of 5 s.

At different interval times, 5 ml of the sample solution was withdrawn and the change in characteristic absorption at the specific peaks was measured using an UV vis spectrophotometer (Jasco 530), from which the concentration of dyes was inferred.

At different interval times, 5 ml of the sample solution was withdrawn and the change in characteristic absorption at the specific beaks was measured using an ultraviolet visible (UV vis) spectrophotometer (Jasco 530), from which the concentration of dye was inferred.