Sentence examples for the slope length from inspiring English sources

In contrast, for large horizontal SOFs relative to the slope length, the two methods agree.

The slope length (L) factor is derived as its topographical factor.

L can be calculated for large watersheds using the unit contributing area (UCA) or the slope length as input parameters.

The purpose of this study was to develop an improved method to estimate the slope length and LS factor.

The slope length and LS calculated by LS-TOOLMFD both agreed better with field data than with the calculations using the LS-TOOLSFD and UCA methods, respectively.

As the slope length increased, soil erosion rates initially increased and then decreased, indicating that the upper section was dominated by erosion and the lower section by transport.

However, the final microstructure of the ingot depends on several process parameters such as cooling rate, incline angle of the cooling slope, length of the slope and initial melt superheat.

The latter effect was achieved when soil loss was predicted using the USLE-M but not when the USLE/RUSLE slope length factor for a segment using an effective upslope length that varies with the ratio of the upslope runoff coefficient and the runoff coefficient for the slope to the bottom of the segment or cell was used.

In the situation of water logging after subsidence, the maximum modulus of erosion would decrease if the accumulated slope length were reduced.

In the USLE the factors of slope length L and slope steepness S are combined together as shown in Figure 62, but this is only for convenience and the two factors derive from two separate and different relationships.

The operating variables evaluated during the pilot-scale testing in India were the table slope (length-wise angle), the table oscillating frequency, and the main fan motor speed (Honaker and Luttrell 2007; Gupta et al. 2012).