Sentence examples for the same coatings from inspiring English sources

The same coatings that are supplied by the multinational coating suppliers and used by the multinational can-makers, are also supplied to and used by the smaller can and closure makers.

The same coatings are applied to a set of planar silicon chips.

Hardness increases with increasing oxidation temperature, a similarity that is observed for the same coatings during thermal annealing in an Ar/H2 atmosphere.

In general, the nickel alumina coatings deposited by pulse current were harder than the same coatings produced from the same bath with dc current.

On the contrary, the same coatings deposited using the HPDL source exhibits no change in the microstructure of the NiCrBSi matrix and display an expected monotonic increase of composite hardness with WC/W2C amount.

The same coatings applied to (111 Ni, when incorporated into the oxide without the coarsening of CeO2 particles, decreased the oxidation rate to values as low as that predicted from the lattice diffusion of Ni in NiO.

The CrN coatings showed a denser microstructure than the Cr2N coatings, whereas the Cr2N coatings exhibited a smaller grain size and surface roughness than those of the CrN coatings for the same coating thickness.

For comparison, the conventional Ni P electroplating technique without mechanical ball-rolling was also used to deposit Ni P coatings under the same coating conditions as those adopted in the mechanically assisted electroplating.

Assuming the same application rates giving the same coverage, these shares will approximate to an area-related basis for the share of the coatings market.

To determine the level of residual stresses in the as-sprayed coating/substrate systems a three dimensional finite element model is developed and also tested for same coatings but aged under, high temperature and rich water vapour atmosphere.

Silicon content was roughly the same for all coatings; carbon content decreased while oxygen content and surface energy increased with decreasing HMDSO/O2 ratio in hybrid coatings.