Sentence examples for the required peak from inspiring English sources

The experimental result demonstrates that the building could achieve the required peak load reduction and the computation time required by the proposed algorithm is less than 5 min.

With Federer, dispatched in the semi-finals here, and Nadal, a first-round victim, sliding inexorably down their performance curves in relation to him, and Murray increasingly unable to hit the required peak he has reached twice in his career, Djokovic could well end up history's man.

The required peak IOPS for an existing database can be measured using the approach in [41].

However, since the required peak of MIP for neutron layers is very close to the pedestal histogram, it is difficult to separate between the pedestal and 'Champion' histogram.

Furthermore, since the wave energy is highly fluctuating, from both the wave-to-wave and wave states time scales, the required peak power capacity of the PTOs greatly exceeds the time-averaged power delivered to the grid.

Table 1 gives a summary of the required peak entrance dose for 3 different target volumes, considering an interlacing geometry with 50 µm FWHM from either 4 ports (200 c-t-c spacing) or 8 ports (400 c-t-c spacing).

It is seen from Figure 5 that as K increases the required peak-power (i.e., IBO) of OFDM/TDM is reducing; for the average BER = 10-4, IBO can be reduced by about 1.3, 2.9 and 5.1 dB, compared to the conventional OFDM, when K = 4, 16, and 64, respectively, as shown in Figure 5.

As K increases the required peak-power (i.e., IBO) of OFDM/TDM is reducing; for the average BER = 10-4, IBO can be reduced by about 1.3, 2.9, and 5.1 dB, compared to the conventional OFDM, when K = 4, 16 and 64, respectively, as shown in Figure 4.

Calculate the required height for the newels.

The quality thresholds for the mutational analysis were a required peak height of 30 relative light units (RLU) for "passed" quality and 10 RLU for "check" quality.

Three different control strategies are developed and tested in this test rig and the results revealed that despite the drive limitations to acceleration levels, well above 1 × 104 rpm/s, these do not significantly affect the power take-off efficiency, because the required acceleration peaks rarely achieve these values.