Sentence examples for the receiver operation from inspiring English sources
Simulation results match experimental data, thus allowing us to infer useful information on the receiver operation.
The detectability of the presented test statistics is investigated in terms of the receiver operation characteristic.
Results demonstrate how the receiver diameter and the axial spacing between its inlet and outlet holes have the highest influence on the receiver operation.
For this, two issues are typically calculated: (1) area under curve (AUC) for the receiver operation characteristics (ROC), and (2) early enrichment, e.g. upon the top 1 %.
Conversely, proactive selection can facilitate the receiver operation and system design while all the cooperative nodes stay idle except the opportunistic relay during the transmission.
Our new expressions show how the ratio of the Nakagami parameter m and the average signal-to-noise ratio which affects the receiver operation characteristics (ROC) curves.
The third one is relevant since the receiver operations of a V-BLAST system can be considered as performing Gram-Schmidt orthogonalization [25], whereby inter-symbol interference (ISI) as well as inter-channel interference (ICI) effects are suppressed.
The receiver operations before the iterative data bit estimation were already described in Section 2. In this section we discuss in more detail the operations performed inside the iterative data bit estimation block, shown in more detail in Figure 6. Figure 6 A block diagram presenting the operations performed inside the Iterative data bit estimation.
After multivariate logistic regression analysis, 10 risk factors were included in the prediction model (age, APACHE II score, coma, diagnose group, increased urea, infection, metabolic acidosis, morphine use, sedation use, emergency admission) of which the area under the receiver-operation characteristic curve (AUC) was 0.87 (95% CI 0.85 to 0.89) and after bootstrapping 0.86.
The principle of the superregenerative receiver operation is as follows.
It means that the malfunction can occur by this leaked signal because the threshold power level in the ETC receiver operation is prescribed by dBm. Figure 13 Measurement situation on the adjacent lane in case of water sprinkler exits in ETC lane.
