Sentence examples for the readout process from inspiring English sources

The readout process is achieved by detecting the difference on the sensing current between highly conductive crystalline state and highly resistive amorphous state.

The readout process of ferroelectric probe memory adopts a very different mechanism from other probe storage memories, as its readout operation can only be conducted under "0" state.

However, a capping layer with high electrical conductivity is usually not desired as this would cause the presence of the short circuit during the readout process [104].

The readout process of ferroelectric probe memory apparently requires an erasing of the previously written data, which is known as "destructive readout" [58].

The readout process is controlled by the trigger processors which may decide to reject an event during its acquisition.

During the readout process, a read resistor whose resistance strongly depends on the temperature is integrated in one of the side-arms of the three-legged cantilever design, which is heated to around 300 °C.

The detection limit of the FIS is affected by many factors: the performance of the entire system, the brightness of sky and telescope emission, readout process, and the distribution of the celestial sources.

The most of the system can run as slow control; only readout process has realtime requirements.

Considering the row-readout process and using the dual sampling approach, it is possible to resolve the saturation problem of W and improve the sensitivity by using two W values at the same time.

In terms of readout process, a short tip-sample distance on the order of 10 nm or less is required in order to obtain a readout image with high resolution.

However, the energy consumption caused by thermo-mechanical probe memory seems to be problematic as the entire tip needs to be heated to perform write and readout process.