Sentence examples for the range of the experiment from inspiring English sources
Due to antioxidant effect of INH in the range of the experiment, the antioxidation of INH-SOD was strengthened with increasing INH concentration.
The cathodic reaction is found to be strongly dependent upon gaseous sulfur dioxide content, but nearly independent of oxygen, within the range of the experiment.
Furthermore, the fast moving ion packet gives rise to a Doppler shift of the counter propagating IR pulse, which accounts for 2 – 5 cm-1 over the range of the experiment and has been corrected for.
After addition of INH during the range of the experiment, the conformation and microenvironment of Cu/Zn-SOD are changed, but the activity of Cu/Zn-SOD is not changed.
Data for in-use open container stability does not have to be collected at a closed container time of interest to estimate in-use degradation at this time point as long as this point is within the range of the experiment.
For all the cell lines, we evaluated a linear relationship between the degree of proliferation and cell number within the range of the experiment.
Within the range of the experiments, product yield is found to increase with an increase in reaction temperature and residence time.
The use of the developed evolutionary optimization algorithm allows the calculation of the Pareto-optimal set of designs under any combination of engine speed and output power, defined in the range of the experiments.
The predictions agreed well with the experimental values with a satisfactory correlation coefficient in the range of 0.9249 0.9988, the absolute fraction of variance in the range of 0.8753 0.9976, and the mean relative error in the range of 0.0008 0.54%, moreover, the root mean square error values for the ANN training and predictions were very low relative to the range of the experiments.
Within the range of the experiments, the preferred combination of process parameters was determined to be zirconia nanoparticle content in the plating bath of about 5 g/L, ultrasonic (35 kHz) DC electrodeposition with current density of 11 appliedapplied cathode rotating rate of 600 rpm, yielding hardness, wear and corrosion rates of about 8 GPa and 1.4·10−6 mm3/Nm and 6 μA/cm2, respectively.
Within the range of the experiments, the preferred combination of process parameters was determined to be nanofluid concentration of 2 wt.%, deposition time of 15 min, applied voltage of 23 V and suspension pH of 3, yielding roughness and deposited mass of 520.9 nm and 161.6 × 10− 4 g/cm2, respectively.
