The final idea is to highlight the increase in quantity as a percentage, because this percentage is always mathematically larger than the percent decrease in cost of the same nominal value.
The percent decrease in RMSE value was found to be highest for Fe (14%, NSV = 79) in Alfisols followed by pH (9%, NSV = 660) in Vertisols while it varied between 3 and 8% for other soil attributes.
In vivo, the percent decrease in IOP from baseline was significantly greater in the treated eye for both topical drug and drug-loaded microspheres versus blank microspheres throughout the 4-week study, with no evidence of migration or foreign body response.
The percent decrease in the number of US examinations done in radiology vs. those performed outside radiology is probably related to a marked increase of the use of US by non-radiology clinicians rather than to a decreased attention to this technique by radiologists.
For the percent decrease in kernel numbers, the X. bovienii supernatant treatment exhibited the strongest effect resulting in an average of 9% loss in kernels in each panicle, followed by 10% in the infected cadaver, 10% for S. feltiae IJs, and 22% for P. lilacinum 108 in treatments (Fig. 3).
After each bleach exposure, the value for the percent decrease in YFP signal approached 100%.
Interestingly, the effect was not seen in the soleus muscle even though the basal expression of PTEN and the percent decrease in PTEN were greater.
However, for a sample of 8 cells, the percent decrease in the MTF LF area evoked by the addition of noise remained relatively constant across a range of intensities, as shown in figure 5e.
The effect (or lack thereof) of each agent is presented as the percent decrease in cGI units (% −ΔcGI), compared to the control cGI of that isolate in the diluent (e.g. methanol or NaOH) that was used for the specific chemical being evaluated.
The absorbance of each well was measured at 405 nm, background signal from the blank wells was subtracted from experimental wells, and the percent decrease in biofilm was calculated by normalizing the signal from enzyme treated wells to that of wells receiving no enzyme treatment.
Inhibition of killing was measured as the percent decrease in cell lysis resulting from blocking of the tested receptor.
