Sentence examples for the minimum strength from inspiring English sources

Such officers are still counted as part of the "minimum strength", however, which suggests more officers are available than actually are.

Defense Department investigators tested a sample of the cable and found that it broke at roughly two-thirds of the minimum strength required by military specifications.

In this paper, the minimum strength of SiC components was calculated by Monte Carlo simulation, and the minimum strength evaluation method of SiC components was developed by using the results of simulation.

The minimum strength of interaction was established by competition studies using soluble synthetic peptide analogs, which showed half-maximal inhibition of yeast binding to CdS at ∼2 μM peptide.

The RG-FA geopolymers had sufficient compressive strength be used as structural masonry units and needed only a low amount of heat treatment to achieve the minimum strength requirement.

Also, the minimum strength (about 6.94%% of the base material) occurred in a sample welded with rotational speed of 780 rpm and traverse speed of 62 mm/min.

For strain rates greater than 2.00 × 10− 3 s− 1, as the moisture content increases, the strength first decreases to a minimum value, then increases to a maximum value, and finally decreases toward that the ice strength; the minimum strengths are not always less than the ice strength, and the maximum strengths are not also always greater than the strengths at the optimum dry densities.

The minimum strengths of the FDI attacks that were successfully detected without triggering any false positive detections (see in Table 3) expectedly increased with the increase of forecast MAPE.

The average maximum compressive strength in both investigation groups is well exceeding to the required minimum strength of 70 MPa by the ISO, although it is significantly higher for gentamicin (p = 0.0001).

If the requisite minimum strength for bone augmentation material is approximately 1.0 MPa, there is a room to further increase the porosity.

One specific concrete mixture which fulfils the requirement for minimum strength of LC 20/22 is used for the test series.