Sentence examples for the low ultimate from inspiring English sources

The low ultimate oil recovery observed during single core CO2 WAG flooding experiments may be attributed to the lack of achievement of miscibility conditions before breakthrough.

Sanchis et al. (2014) reported low mineralization of MCPA (<25 % after 28 days), which is in accordance with the low ultimate biodegradation rate of MCPA by the isolated microbiota.

Methane emissions on this scale would amount to 0.46% of lifetime production in the base case (2 Bcf recovery) and 0.92% for the low ultimate recovery case (1 Bcf).

Of these DILs, HPDBr shows the lowest ultimate phenol concentration of 3.9 g/dm3, and the extraction efficiency of phenol can reach as high as 97.0%.

When using the abovementioned approaches in analysis of multiple member structural systems, the designer is required to arrange the directions of bow imperfections or equivalent transverse loads in such a way that the imperfection arrangement leads to the least constrained solution, i.e. the lowest ultimate load predicted from all possible sets of member initial imperfection arrangements.

In the case of the applied load, the desired beam has the lowest ultimate load.

It can be noted that the highest ultimate capacity exhibited by the concentrically loaded column C-0-0, while the lowest ultimate capacity was achieved by column S-5-5 having single curvature mode and equal end eccentricities of 0.5b, as expected.

In spite of the higher early-time CSOR observed in this case, the 2 m instance resulted in the lowest ultimate CSOR of 3.8 and higher well spacings revealed slightly less favorable results of this value.

The results presented in Figs. 3, 4, and 5 show that flooding core samples with the three different brines at their original salinities resulted in the lowest ultimate oil recoveries.

In the early time of process within 5 years, 15 m well spacing case showed the highest oil recovery among all the three well spacings, however, this well interval case revealed less favorable oil production later, reaching the lowest ultimate oil recovery factor of 48%%.

In contrast, the lowest ultimate tensile strength value was observed in the Ni99.99 deformed at 400 °C.