Sentence examples for the lifting process from inspiring English sources
"Because they are counterweighted to create a balance in the lifting process, we need to figure how to deal with the problems of applying pounds of paint yet keeping that balance," he said.
The go ahead on final designs was only given last September, and since then we have machined the parts, shipped them, constructed on-site, and tested all the software involved in the lifting process.
However, the lifting process may produce excessive stress, which can damage the pipeline.
Thus, the variations in pipeline stress during the lifting process is needed to be studied.
In this paper, a finite element model verified by tests has been established to study the lifting process.
Then, in combination with guidance from engineering practice, the lifting process has been analyzed by the finite element model.
"The LIFT process makes the contractor preeminent," says Rory Coonan, former head of architecture and design at Circle Health, who commissioned Norman Foster's outstanding (private) hospital in Bath – a first for the practice.
This experiment based characterization method was designed to investigate the spraying behavior of the LIFT process, that occurs in certain fluence regimes.
Subsequently, probabilistic design analysis was conducted for the integral lifting process and the key lifting points which influence the stress of lifting zone significantly was derived, at the same time the probability distribution model of lifting height difference was established and validated.
Among them, the vehicle pitch angle originated by the desynchronized height adjustment between the front and rear air suspensions in the height lifting process is illustrated in Figure 2(a), the vehicle roll angle originated by the desynchronized vehicle height adjustment between the right and left air suspensions in the height lowering process is illustrated in Figure 2(b).
A "reference station following station" control scheme enables nonsynchronous height errors between the reference station and the following stations to be controlled within ±4 mm during the whole lifting process.
