Sentence examples for the initial milling from inspiring English sources

The final nanopores with diameters around 60 120 nm are achieved by ion beam sculpting after the initial milling process.

This resulted in an excellent milling surface, albeit it increased the initial milling time significantly.

In one method, called kapika, polished rice is fine-sanded to produce a more lustrous finish; in another, called musenmai, rice is bathed in hot uncooked tapioca after its initial milling to pull off any remaining bran.

In this study, we have adopted fabrication which includes initial milling employing focused ions accelerated at 30 kV with a 5-kV ion beam performing the final thinning and polishing to achieve the required thickness and at the same time remove the 30 kV beam-induced damage layer [13].

Alumina from the aluminum powder in the starting blend, formed in the initial stages of milling using oxygen available from the other elemental powders, combines with yttria to form YAP. The yttria content does not affect alloy formation but reduces the crystallite size and strain significantly in the 5% yttria composition.

According to the simulation results, the wheel rolling resistance, the grinding power consumption and the motor power of the mill were calculated and the mistake in the initial design of the mill was modified.

Regardless of the initial degree of crystallinity or milling temperature employed, MM apparently yields an "oriented amorphous" PET morphology in which the PET chains are locally aligned but rotationally disordered.

The analysis of variance (ANOVA) results revealed that the oxygen flowrate (A) contributed the highest effects to the degradation (63.5%), follows by the initial concentration of palm oil mill effluent (C, 22.32%), titania loading (B, 5.69%), and finally the interaction effect between the oxygen flowrate and the initial concentration of palm oil mill effluent (2.29%).

Three factors were included in the design: milling frequency in Hz (A), milling time in h (B), and the initial relative weight percentage of GO/SPIOs (RPInitial), being loaded into the milling jar (C).

This paper presents a new optimization model designed to minimize kinematics error introduced by the initial setup of a five-axis milling machine.

In lithium cells, the reversible capacities increase with increasing boron concentration for both sputtered and ball milled samples, however, the initial coulombic efficiency is lower than 80%.