Sentence examples for the end located from inspiring English sources

Working here was often a joy, and having Time Out's network of critics a terrific boon – the restaurant reviewers tipped us off about the great Korean cafes on St Giles High Street, while the clubs editor would rave about The End, located in an old brewery off New Oxford Street.

In this case, the resultant force of the tractions acting on the end located at x 3=l is F e 3 and the point O is fixed.

The rps12 gene is trans-spliced, with the 5' end located in the LSC and the 3' end duplicated in the IR regions.

If you're dealing with a molecule that has both double and triple bonds, start the numbering from the end located closest to any multiple bond.

So a high-gain and low-noise receiver is needed, which includes two parts: the front end near to the feeder and the back end located in the controlling room.

In agreement with other known RRM nucleic acid complexes, the DNA is bound to the RRM β-sheet, with the 5′ end located on the first half (β4β1) of the sheet and the 3′ end on the second half (β3β2).

To further shorten the remaining gaps, we gathered the paired-end reads with one end mapped on the unique contig and the other end located in the gap region and performed local assembly with the unmapped end to fill in the small gaps within the scaffolds.

To further shorten the remaining gaps, we gathered the paired-end reads with one end mapped on the unique contigs and the other end located in the gap region, and performed local assembly with the sequences on unmapped end to fill in the gaps within the scaffolds.

In rps12 a trans-splicing event was observed with the 5′ end located in the LSC region and the duplicated 3′ end in the IR region as previously reported in Nicotiana [ 24].

Boreholes with the bottom end located in the lower region of the fractured zone, (20 m above the roof), can draw more methane than those located in the upper region of the fractured zone (70 m above the roof) and those located in the caved zone (2 m above the roof).

Polymer filament is fed by the filament driver through a Bowden sheath to the hot end located on the end effector (yellow component with fan in middle of Fig. 1).