Suggestions(2)
Exact(1)
The second parameter is the deviation phase (DP), which is calculated by averaging the standard deviations of the ensemble CRP curve points for both the stance and the swing phases: (5) DP = ∑ i = 1 p S D i p. DP provides a measure of stability of the organization of the neuromuscular system.
Similar(59)
The accuracy of unit power factor is very good, but the accuracy of plant is poor, which could be caused by several reasons: ① it could be caused by reactive power losses which may be larger than expected in Table 1; ② it is assumed that the sum of inverters' output is less than multiplication of single inverter because of the deviation of phase angle.
Effect of initial stress on wave propagation is observed through the deviations in phase velocity and attenuation amplitude factor for each of the three existing quasi-waves.
The deviation of the phase from the carrier phase is given by: phi_{text{dev}}(t;{a}) = 2pi h sum_{k=-infty}^{infty}a[!k]q t-{kT}_{b}), (9).
The phase deviation (deviation of the phase from segment to segment) of the 2nd and 3rd component is quite small, i.e. the phase is rather constant in time.
The standard deviation of slowness in the MUSIC spectrum estimation, as defined by Goldstein and Archuleta (1991) gives (3)where δt is the deviation of the measured phase arrival time from the expected plane wave arrival time, M is the number of sensors, and Δx is the station separation of the sensors.
During the beginning to main eclipse phase, the deviation values of several air pollutants concentrations from eclipse to control day values vary in a small range from −9 to −2 ppb in case of surface ozone and −180 to −80 ppb for CO.
To prevent increases in data variability by the deviation of the action phase, the BOS velocity, TA, and TAV were aligned by the times of each heel strike of the second, third, and fourth steps, and we analyzed the aligned data until the phase around the heel strike of the next step, as shown in Fig. 3.
The standard deviation of phase tracking errors is around 5°.
Compared with conventional Fourier transform profilometry (FTP), the standard deviation of phase difference between these two methods reaches only 0.75%.
The standard deviation of phase differences between sweep and buffered copies (i.e., at 200 kHz repetition rate) retrieved from the same measurement was 47 mrad (0.79 mm/s).
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com