Sentence examples for the curing condition was from inspiring English sources

The curing condition was 120 °C for 6 min.

The size of these specimens was 50 mm × 50 mm × 50 mm, and the curing condition was identical to that of the porous concretes.

The average drying shrinkage after 210-day of ambient curing condition was 2.59 × 10−3 for samples of 25% natural aggregate, while it was 5.08 × 10−3 for 100% MEPS aggregate samples.

An important influence of initial curing condition is observed due to the creation of new surfaces and an increase in porous connectivity.

Thermo-mechanical behaviors of both homogeneous mortar and heterogeneous concrete samples under standard curing condition are simulated, focusing on the production mechanism of self-restraint stress.

More than 5000 specimens with 676 unique combinations of mixture proportion and curing condition were tested.

Cement type, W/B and curing condition are very influential factors concerning chloride penetration (Song et al. 2008; Guneyisi et al. 2009; Yildirim et al. 2011).

In the application of this method, POFA admixture percentage, topcoat powder-to-binder ratio, water-to-binder ratio, latex agent content, particle size of POFA, and curing condition are selected as control factors.

The phase behaviour of the DDM-cured ER/PEK-C blends was greatly dependent on the curing condition and was affected by both the thermodynamic and kinetic factors.

Two curing conditions were considered with humidities of 98% and 70%.

Results further indicate that compressive strength is not significantly affected by the curing condition when silica fume is used in the activating solution in comparison to the use of sodium silicate.