Sentence examples for the cold wire from inspiring English sources

Readers may have seen the newsmaking pictures of Harlow's experiments in the nineteen-fifties, which demonstrated that parents are not seen by their offspring as mere food sources: baby monkeys cling to terrycloth surrogate mothers, shunning the cold wire ones that hold milk.

Flow measurements are achieved with laser anemometry and the temperature field is determined using the cold wire technique.

This sensor is sampled at 800 Hz, but is subsampled at 100 Hz for the analysis to be consistent with the cold wire data.

Based on the experimental results, the relationships between the strength increase and microstructure development during the cold wire drawing were studied to reveal the strengthening mechanism.

In the temperature and humidity plots, the blue curve corresponds to the sensors on iMET, the red curve to the DH sensors, and the black curve to the cold wire (CW) sensor.

However, the less-than-optimal frequency response (100 Hz), combined with the high noise level of the cold wire and pitot sensors, prevented the use of the spectra above a certain frequency, leading to rather narrow inertial subranges in the turbulence spectra.

We walked around the fence, plucking the cold wires with our fingers.

This research presents a new insight on the solidification path of alloy 625 weld metals deposited by the TIG cold wire process on the C Mn steel plates.

Crystallization of the amorphous phase led to a broadening of the angular distribution of 〈111〉 preferential orientations of grains along the axial direction as relative to the original 〈111〉 axial fiber texture of the nanocrystalline domains produced by the severe cold wire drawing deformation.

Only the PTU data taken by the iMET sensors, the TU data taken by slow response sensors on the UAV (denoted by DH, see Table 2), and the temperature data taken by the fast response cold wire (denoted by CW) are valid during the initial ascent by balloon, since the UAV was carried aloft by the balloon and not flying under its own power.

Research work in the field of cold wire forming showed that it is possible to influence the process by appropriate corrections of the position of bending tools.