Sentence examples for tests were reproduced from inspiring English sources

Measured ignition delay times from the RCM tests were reproduced well by the model for high pressures, but underpredicted at 15 bar.

Shear and tension tests are reproduced on two connection systems and results are compared to the test data obtained from similar configurations.

Shear tests are reproduced on nailed steel-to-timber joints in Cross-Laminated Timber and results are compared to the experimental test data obtained on similar single fastener joints.

The results of focused wave group tests and a 6-hour (full scale duration) test are reproduced numerically by re-application of the wave paddle signal in a fully nonlinear potential flow wave model.

The effective stress field at the gear tooth during the fatigue test was reproduced by finite element modelling to check using a multiaxial fatigue criterion whether the fatigue crack initiation can be considered as the precondition for failure.

The experimental test was reproduced numerically by finite element analysis and the recording of deformed grey level images by a CCD camera was simulated trying to take into account the most significant parameters that can play a role during an actual test, e.g. the noise, the failure of the specimen, the size of the grid printed on the surface, etc.

The observed trends of tensile stresses in the geosynthetics and relative displacements at interfaces in the laboratory testing are reproduced by the numerical models to an acceptable degree of accuracy that would be appropriate, using site-specific input data, for use in commercial design.

Also full-scale experiments were performed and for comparison some of full-scale test wind conditions were reproduced in wind tunnel tests.

We tested whether the results were reproduced at tissue level.

Although our results correlated with the known graded samples (r = 0.72, P < 0.05), the 1+ readings were reproduced in only 8 of the 15 tests (53%) and the 2+ readings were reproduced in only 2 of the 15 tests (13%) (Table 2).

The results confirm that the diffusion tests can be reproduced with a high degree of accuracy (±0.2 %).