Sentence examples for tests of the coating from inspiring English sources

The critical failure load determined by scratch tests of the coating with c-AlN segregation was highest among all the coatings studied in the present work, which indicated that the coating has the best adhesion.

Impedance tests of the coating showed that the coating is susceptible to electrolyte penetration, especially by acetic acid.

The startup chose a select number to pay for the development and testing of the coating for its products.

Hardness test of the coating was measured with a Vickers hardness tester, using 200 g load.

Testing of the coating specimens indicated that high frequency thermal cycling (1 h cycle time) could significantly degrade the coating performance.

The sliding wear test of the coating carried out against WC-Co ball revealed that the wear resistance of the coating improved upto seven times than the uncoated Ti-6Al-4V substrate.

Wear tests of the gradient coating reveal good adhesive friction and wear properties when sliding against steel under dry conditions.

Coated H13 substrates were oxidized in a tube furnace under atmospheric conditions at specific temperatures determined from TG/DTA tests of the same coating on alumina substrate.

Tests of the TiN coating made using 10 μm beads running against an aluminum counterface showed substantial improvement when the microreservoirs were present.

The spectra from the 2014 (MAAS) and 2015 (UC) FTIR tests of the roof coating displayed similar peaks and were suggestive of cellulose-based compositions.

From the 0T-bending test, delamination of the coating layer was observed from heat-treated sample for 240 s which is composed of over 85% of the intermetallic compound phases.