Sentence examples for tests of structural from inspiring English sources

Coefficients in the formula are based on data obtained from at-sea measurements and from tests of structural models; as a consequence, the formula has been found to give predictions that seem to be in satisfactory agreement with reality.

Even if one could consider that this assumption would be reasonable for short sample periods or in contexts where consumer perception and valuation of quality remain constant over time, the truth is that in the literature parameter constancy is most often rejected by Chow tests of structural break.

Our results, however, provide no support of the EKC for South Africa, both for the full-sample and sub-samples (determined by tests of structural breaks), implying that to reduce emissions without sacrificing growth, policies should be aimed at promoting energy efficiency.

Even so, hippocampal lesions often impair less formal tests of structural learning such as detecting spatial or temporal rearrangements of stimuli (e.g., Save et al., 1992; Agster et al., 2002; Mumby et al., 2002; Manns and Eichenbaum, 2009; Brown et al., 2010; Barker and Warburton, 2011).

By extending the power transformation into linear mixed model setting with NDNQI examples, we found limited difference from subsequent test of structural effects regardless of whether such structure is included or omitted during the parameter estimation for transformation.

The research steps included exploratory factor analysis, confirmatory factor analysis, and testing of structural model.

Table 6 shows the common model-fit indices, recommended values and results of the test of structural model fitness.

Moreover, the application of Digital Image Correlation DICC) technique for fatigue testing of structural component is discussed.

Specimen, produced from A357 aluminum alloy, was successfully tested and can be used as a part of standard procedure for mechanical testing of structural repairs.

This contribution describes the modelling and testing of structural elements by application of an angle bar and spot welding techniques with the introduction of adhesive layers between adherends.

It is considered that the exercise provides a demanding test of structural modification theory resulting in a very useful practical assessment of the limitations of the method.