Sentence examples for tests attained from inspiring English sources

In an early field trial, however, the tests attained the notable distinction, Mr. Crewdson says, of "an astounding false-positive rate of 99 in every 100," causing large amounts of good blood to be discarded, and leading many people to falsely think they had AIDS.

In most cases, this separation is four or five octaves, so the coincidences between partials of sounds with octave or fifth relation are smaller and the octave and fifth tests attain better performance.

In most cases, this separation is four or five octaves, so the coincidences between partials of sounds with octave or fifth relation are smaller and the octave and fifth tests attain better performance.  .

SPT plans to use its new-found capital to: complete its field tests; attain various safety and environmental certifications; ramp up its production; hire personnel to expand its sales footprint to Europe and Asia by the end of 2011; and to develop technology that works beyond crystalline solar panel arrays with CIGS, thin-film and concentrated photovoltaics.

An important finding of most studies was that the combination of cytology and HPV testing attained very high negative predictive values (approaching 100%), which, at least in theory, could safely permit longer screening intervals, thus lowering costs.

Analysis II made continuous stress evaluation throughout a complete driving test attaining a high coincidence with the true road situation especially at the switching interval of traffic conditions.

In most cases, this separation is four or five octaves, so the coincidences between partials with octave or fifth relation are smaller and the octave and fifth test attain better performance.

Test reliability is a concept central to classical test theory and it is commonly stated as a requirement that a test attain a certain level of reliability before it be considered of sufficient quality for practical use.

The best values in shear and peel tests were attained with calcite having the particle diameter of 0.7 μm in both type of epoxy resins providing a good agreement between experimental and theoretical results.

The fluid injection continued until no further oil was produced from the core, i.e., residual oil saturation (Sorw for water injection test and Sorg for gas injection test) was attained in the core.

For Ф1B, eletriptan maintained a low level in whole, whereas for Ф1D, it was observed that all of the tested triptans attained an occupancy of 80%% or higher at maximum.