Sentence examples for testing can be achieved from inspiring English sources
Both tumor cell localization and intracellular Dox release testing can be achieved by measuring the fluorescence signal changes.
Rapid clinical testing can be achieved using existing commercial clinical research organizations and clinical site networks such as the Medical Countermeasures Clinical Studies Network currently envisioned by ASPR/BARDA.
The results showed that nearly constant strain rate and dynamic stress equilibrium over an effective duration of the test can be achieved for UHPC with a compressive strength of about 200 MPa.
Especially, when the composition of the blends of PA6/PC is 7525 and the total amount of added SEBS is 20 phr, drastic enhancement of the impact strength and of the elongation at break in the tensile stress-strain tests can be achieved by varying the ratio of SEBSgMA to unSEBS.
Good sensitivities and specificities of a test can be achieved only with a large sample size.
Only one sequencing lane of an eight lane flow cell was utilized for each sample, indicating that a cost-effective clinical test can be achieved.
We agree that RIDTs may be of little benefit in situations where a timely diagnosis by reverse transcription PCR (RT-PCR) or optimized direct fluorescent antibody tests can be achieved.
As apparently seen from Table 3, it successfully applied the treated water to the production, and the oxidized starch product quality testing standards can be achieved.
One of these programs – faecal immuno-chemical testing (FIT) can be achieved entirely through the postal system, with participants receiving a positive or negative result letter with follow-up advice.
Moreover, activation or inhibition of nerve excitability with these tested monoterpenes can be achieved by altering their chemical structures, and this can lead to further implications for target-directed drug design.
A significant reduction of operating time and cost consumed by the real engine test bench can be achieved, if a small subset of steady state measurements are used to compute a meta-model for the pressure loss.
