Sentence examples for test tanks from inspiring English sources

Analysis is conducted at intermediate scales using two-dimensional (2-D) test tanks to create heterogeneous systems with complex entrapment architecture and non-uniform flow fields.

This paper should be of use to scientists and engineers seeking to design flumes, test tanks and basins that create sea-like test conditions, thus improving the scope and range of laboratory testing.

In PV and PCV presentations, one large (∼5.0 cm) cichlid was placed in the visual stimulus tank, between the fry test tanks on either side (Figure 1).

During chemical stimulus presentations, chemical stimulus water was dripped into each test tank at constant rate; following chemical stimulus presentations, fry were removed from test tanks, the tanks were rinsed and then refilled with treated tap water, and fry pairs were returned to test tanks.

A numerical model, validated using data generated in test tanks, was used to simulate mass removal during surfactant injection.

Finally, several experimental modal analyses were performed on two different test tanks filled with different water levels in order to verify the accuracy of the theoretical results.

Using the same base of refrigerating system, three types of condensers were tested: tank-wrapped D-tube, roll-bond and microchannel heat exchangers.

Open image in new window Fig. 7 Heterogeneous test tank (hypothetical) used in this numerical modeling investigation.

Trials with the vehicle in a test tank have been performed.

The target was placed at various distances from the receiving stage in a black-walled 25 m long test tank, filled with water of two different turbidity levels.

PCE was injected into the source zone through 15 equally spaced injection ports located on the top of the test tank.