Sentence examples for test owing to from inspiring English sources

These authors explain that the friction coefficient is higher at the beginning of the test owing to the absent of the tribo-chemical film.

However, in terms of our DCB fracture test, owing to that the pre-crack does not propagate expectedly along the interface of facesheet/honeycomb core, a new fracture mode, namely IKP (initiation of interlaminar delamination, kinking into facesheet and propagation of interlaminar delamination), has been found.

This may be due to a greater sensitivity of the REG test, owing to the fact that it incorporates the uncertainty due to the imputation of haplotypes.

The impedance profiles at potentials negative to −75 mV were converted from band pass (iBP = 1.61±0.32) to low pass ones (iBP = 1.01±0.02; paired paired Wilcoxon Mann–Whitney test) owing to an increase in the cell's response to low frequency signals.

The VDRL should not be recommended as a screening test owing to lack of sensitivity.

Categorical variables are described as proportions and were compared by the Z test owing to the 1-sided testing.

Since its advent, this method has gained increasing interest in the community of dynamic mechanical testing owing to its ease of manipulation.

In current practice, lateral strengths of shear wall panels with cold-formed steel framing are primarily determined by tests, owing to the lack of applicable analytical methods.

Confidence in the results was also achieved by conducting a number of sensitivity tests; owing to limited computing resources, they were of course less extensive than one usually carries out in 2-D environments.

These findings were reminiscent of under-recognized historical observations that were already suggestive of acquired immunosuppression in septic patients, such as unreactive skin testing owing to defective type IV hypersensitivity or altered in vitro cytokine production by monocytes, both associated with increased mortality [28-30] [28-30]

It can be seen that the real-part permittivity (in short, permittivity) values of all the composite samples were independent of frequency before and after wear testing, owing to the concentration of CNFs (3 wt%) in the composites being lower than the percolation threshold [39 42].