Sentence examples for test of the load from inspiring English sources

The result of the non-parametric spectral density estimation and the parametric Ljung Box test of the load factors of the EM and EF flights is given in Table 7.

Testing of the load bearing capacity of corrugated board boxes is often associated with uncertainties, e.g. the creases along the edges of the side panels introduce eccentricities.

The test bench of the load torque estimation experiment consists of a servo motor and a hysteresis dynamometer, while the contour following experiment is conducted on an X Y table.

For the calibration and testing of the loading device a biomechanical measuring system has been used.

In the impact DCB tests, the variation of the load against crack propagation is different from the static-test value because of the dynamic effects [5, 9].

A simulation test of the system for varied load motor conditions proved that the system is preferment.

With the increase in the ρ value in beams, the ratios of test load to the load calculated using ACI 440 and ISIS Canada increased.

However, for the C16-ZrP oil sample tested under the load of 80 N, the wear damage, as shown in Fig. 8c, becomes very large and elliptical in shape with a long diameter of around 2600 μm, a dramatic increase as compared to the same sample tested under the load of 70 N (round wear scar of ~ 600 μm in diameter).

Related to this tramway network development the required static calculations and the loading test of the Rákóczi-bridge was executed by the BME Department of Structural Engineering.

Experiments are made by indentation (hardness, creep, stress relaxation), scratch test (determination of the critical load), glossy reflection and wear.

First principal stresses were simulated for scratch test geometry in the load range of 7.5 15 N.