Sentence examples for test of equation from inspiring English sources

Assuming the K-1 significant examples of epistasis had been discovered, a complete scan of every SNP in the cis window tested for evidence of epistasis with the v-eQTL (using a likelihood ratio test of Equation 2 nested into Equation 1, testing the hypothesis cK = 0), conditioned on all previously discovered interactions.

Further, alternatives to the test statistic of Equation 1 can easily be devised, For example, for any non-leaf node n we can introduce: 3 where c1(n), c2(n) are the two children of n.

The χ test of structural equation models became widely available with the appearance of LISREL-III in 1976 [ 4].

When the PAM signal y(t)=0 in the hypothesis testing problem of Equation 36, the problem becomes a detection problem.

The likelihood-ratio (LR) test of independent equations was used to test the null hypothesis of no correlation between error terms from each equation.

For this, a previous quantitative test of these equations should be made in order to determine their theoretical foundations, mathematical simplicity and accuracy in predicting the thermodynamic behaviour of these systems.

Not only 95% but also 98⅓% posterior intervals were calculated to facilitate a more conservative joint test of three equations with total significance level no larger than 1⅔% * 3 = 5%.

A comparison of k a,i calculated by Equation 4 and k a,i directly measured for different anode-filter combinations and different values of d has been done (using four different mammography devices whose yield was Y tb, located in different hospitals) to test the accuracy of Equation 4. Note that both Y 0 and Y tb must be calculated at the same value of kVp (28 kVp in this work).

To further test the utility of Equation [8], we apply it to another data set.

This study was prompted by fortuitous use of NK cell activity measurements in a debate over the testing of structural equation models.

The chapter also covers dynamic fracture tests, for assessing fragmentation and spallation, as well as Plate Impact tests, for generation of Equation of State data and dynamic yield strength values.