The results are presented in terms of the sample means and percentiles 25 and 75 for each outcome variable.
Correlation analysis showed that physico-chemical parameters do not vary much in terms of the sampling sites.
The results presented here have several limitations, most notably in terms of the sample and the simplicity of the measures used.
In either case, the optimization requires that the cost and precision be expressed in terms of the sampling design and sample sizes.
Several experimental research studies about the choice of digitiser properties for liquid scintillators have already been conducted in terms of the sampling rate and vertical resolution.
Rules for fault detection and accommodation are derived from the fault-free stability properties in terms of the sampling rate and delay size.
The proposed estimators are explicit closed-form expressions in terms of the sample observations and can thus be easily computed in practical situations.
The error between the measured values from SP and SCLM was calculated, respectively in terms of the sampling position and tool type.
In terms of the sample without Ar ion etching, the relative percentage of Ni0 is 9%, which is much smaller than that (48%) of the sample with Ar ion etching.
We also observe that an increased number of samples will be required to obtain an accurate SNR estimation, especially at low SNR. Figure 2 Estimation performance in terms of the sample size N. (a) 4PAM and (b) QPSK.
