Sentence examples for tensile test sample from inspiring English sources

The elongation during each test was determined by optical measurement (video extensometer) of the displacement of two marker points placed along the waist of the tensile test sample.

Ideally, the length of a tensile test sample would be at least 5 times the width.

The fracture surfaces of the tensile test samples have been studied.

Tensile test samples having cross-section of 10×10 mm2 and a length of 30 mm were used for the experiments.

SEM and EDX analysis were used to study the presence of oxide bifilms and fracture surface of tensile test samples.

Fracture surfaces of tensile test samples with and without compost degradation or UV irradiation were analysed by using scanning electron microscopy (SEM).

As the superimposed hydrostatic pressure increases, the fracture surface of the hydroformed tube is also shifted from the P-type mode to C-type mode, a typical transition found experimentally for sheet tensile test samples deformed under superimposed hydrostatic pressure.

Tensile test samples were cut into a dog bone-shape from the sheet with the dimension of 40 mm (length) × 2 mm (width).

Tensile test samples were prepared in the x-direction (sheet rolling direction) and the z-direction (in sheet plane direction that is transverse to the rolling direction), and compression test samples were prepared in the y-direction (sheet thickness direction).

For both the perpendicular and parallel directions of tensile tests, samples had a ductile fracture with many dimples inside of the larger dimples.

Austenite fraction analysis on the tensile tested samples suggested that in all three steels a significant percentage (35 50) from the total retained austenite undergo strain induced transformation to martensite.