Sentence examples for template treated with from inspiring English sources

Figure 3 shows the PDMS pillar arrays molded into the master template treated with FOTS, with additional surface treatment using toluene or hexane solvent.

Preparation of the 5′-radiolabeled RNA template was performed as follows: The gel-cleaned RNA template was treated with shrimp alkaline phosphatase (SAP, Fermentas) at 37 °C for 60 min and then incubated at 65 °C for 25 min to inactivate the enzyme.

To remove the barrier layer, AAO template was treated with 5 wt% phosphoric acid solutions at 35°C for ca. 20 min. The SEM image of the obtained structure is given in Fig. 3b, which shows the surface of the AAO template with opened AAO barrier layer.

RNA template was treated with DNase to avoid the contamination by genomic DNA in the reverse transcription-PCR of this intronless gene.

All these methods were based on PCR and the template was treated with sodium bisulphite.

Diffractogram of zirconia prepared by template-assisted treated with sulfate and heated under different calcination temperatures showed a slightly different (Fig. 1).

Approximately 500 ng of SMRTbell templates were treated with the Tet1 enzyme at 37°C for 60 minutes followed by proteinase K treatment at 50°C for 60 minutes.

Reverse transcription reactions were performed using the SuperScript First-Strand Synthesis System (Invitrogen, CA), and the RNA templates were treated with DNase to avoid genomic DNA contamination.

The template was first treated with a self-assembled monolayer (SAM) of octadecyltrichlorosilane (OTS) only on the protrusion surface using μCP, and then treated in SnCl2 solution to activate the surface of the trenches for the selective electroless plating (ELP) of silver inside the trenches.

These mixed template DNAs were treated with bisulfite and then used to generate SEPT9- and TMEFF2-specific PCR products.

Nucleosomal templates mock-treated with BS, treated with BS inactivated by glycine treatment or untreated were used as controls.