Sentence examples for temperature of the erosion from inspiring English sources

Temperature measurements were made by an infrared camera for target diameter of 100 mm, pulse repetition frequencies of 1 and 10 kHz, and discharge average pulse currents of from 2.5 to 35 A. For the case of hot target, surface temperature of the erosion zone increased up to 1750 °C and melting occurred.

A temperature dependence of the erosion yield has been observed for Si and C. The temperature of the maximum increases with ion energy from about 350 K for 20 eV to 570 K above 100 eV for Si, which is always about 250 K lower than for graphite.

The spectra of plasma, the surface temperature of the electrode and the erosion rate were measured by a spectroscope, a radiation thermometer and an analytical balance, respectively.

Meanwhile, the surface of the stainless steel may partially melt at this temperature assisted by the erosion of N2 and H2.

Therefore, the configuration of the extended-gate field effect transistor can reduce the influence of the temperature, light and the erosion by the solutions.

The temperature of the maximum of the chemical erosion increases from below 600 to above 850 K with ion energies from 15 to 300 eV.

Mr. Metzenbaum spoke of the erosion of public confidence in government.

In case of erosions, specimens were taken 2 cm above the tip of the erosion.

The microstructure evolution and erosion performance of the coatings annealed at different temperatures were investigated and the erosion mechanism of the intermetallic coatings was examined through the surface morphology and cross-sectional microstructure of the eroded coatings.

At high temperatures, the strong erosion of B vapor, not only changed the primary structure of CFs, but also produced more flaws.

The nitrided specimens at 1173 K, which is below β-transus temperature of Ti6Al4V, displayed the best erosion resistance measured by their corresponding cumulative material loss, about two times higher than non-treated Ti6Al4V.