Sentence examples for teflon plate from inspiring English sources

The formed water slurry was put on a teflon plate and left drying at room temperature.

The mixtures were casted onto a Teflon plate and dried in a humidity chamber (37 °C, 50%% ± 5 relative humidity) for 24 h to remove the solvent.

Then the mixture was cast on a Teflon plate and dried in vacuum at 70°C for 24 h to form polymer electrolyte complex films.

500 mg graphene oxide-chitosan powders were dissolved in 25 mL 2% (v/v) acetic acid aqueous solution by ultrasonication for 30 min. The homogeneous solution was then cast onto a teflon plate, left to dry at room temperature and subsequently peeled off as a free-standing film.

The mixture and MDI were then stirred at 100 rpm for 5 min at room temperature and then casted onto a Teflon plate and dried in humidity chamber (37 °C, 50%% ± 5 relative humidity) for 24 h to remove the solvent.

After freeze-drying overnight, scaffolds were immersed in three changes of double-distilled (dd) H2O to dissolve the sucrose, and gently removed from the Teflon plate with a fine-tip spatula.

Then the film-forming solutions (200 ml) were cast on flat 30 × 30 cm Teflon plates.

The main and side chains of a polymer align in different directions when heated and pressed between Teflon plates.

In vivo studies were fulfilled by subcutaneous implantation of Teflon plates coated with the tested films in mice and analysis of the population of cells on the surfaces.

Teflon plates coated with the tested films were inserted subcutaneous in mice and analysis of the population of cells on the surfaces was performed.

The elastic recoil of the test lungs used is not achieved by using an elastic balloon but rather by having a fairly non-elastic balloon placed between two elastic Teflon plates.