Sentence examples for technical sample from inspiring English sources

EDA and TIE are integrated biological and chemical approaches which aim to identify those compounds in an environmental or technical sample (water, soil, sediment, air, food, consumer product and technical mixture) that cause a biological response.

Fig. 1 a surface photo of a gypsum-charcoal technical sample irradiated with 1064 nm (10 pulses at FIR = 1.5 J/cm2) and a combination of 1064 nm and 355 nm (10 pulses at FIR = 1.5 J/cm2 and FUV = 0.9 J/cm2).

Approximately 1000 cells per technical sample were pinned onto ZTSC agar and grown at 18 °C (see Section 2.7).

There were two peptides with spectral counts over 10 that were detected only in a single technical sample at either time point.

The peptide SCG2[205 216], which was detected 18 times in a single technical sample, is a truncated form of three other SCG2 peptides that were detected at both time points.

Technical sample effects were estimated by mean relative levels of the two spike-in controls (one measurement per bead set and control, eight measurements in total) and each sample was normalised by subtracting the estimated technical effect.

The determination of atmospheric deposition in forests can be accomplished using technical sampling devices (bulk samplers, wet only samplers), biomonitors or modelling.

b d SEM photos of reference-untreated b, IR c and UV d irradiated technical samples at the above-mentioned parameters.

Assumptions were made to transfer the pollen deposition measurements from this technical sampling to pollen density on Urtica leaves.

The relationship between the results of standardised technical sampling using the PMF sampler and leaf pollen density measurements was experimentally evaluated based on parallel field measurements.

Hofmann et al. [2] focused on the distance relationship in pollen deposition as measured by the PMF standardised technical sampling method.