Sentence examples for tape as shown from inspiring English sources

The SC consists of a repeating double-molecule motif forming a 1D tape as shown below.

With pristine-coated Ag NW thin film, the Ag NW layer is easily detached from the surface of PET by the scotch tape as shown in Figure 6a.

This type of the smart cutting tool design comprises of a cutting insert, a single-layer piezoelectric film, a metal shim and two pieces of insulation tape, as shown in Figure 2(a).

For example, polylactic acid (PLA), the most popular 3-D printing polymer, can be printed directly on Kapton tape as shown in Fig. 1 or can be printed directly on glass after pre-treatment with common glue sticks.

To compare the effect of second pressing with traditional heating process [46], a film of pressing transfer without second pressing was heated at 120°C and also tested by 3M sticky tape as shown in film 2 of Figure 5.

For OCT measurements, a custom-made instrument to quantitatively stretch or shrink the skin was attached to the skin by an adhesive tape as shown in Fig. 1.

But the point there is really how Hillary Clinton, who was supposed to be seen as pro-woman, who was trying to really milk this tape as showing Donald Trump as being against women, it was a reminder that Hillary Clinton had treated women very poorly in the past, and that included the women in that room.

The fabrication process of nanofluidic chip includes four steps, which are (1) fabrication of master wafer, (2) nanoreplica molding of photonic crystal gratings on the glass based UV curable epoxy, (3) depositing high reflective material TiO2, and (4) direct bonding between PC and laser cutting tape layer, as shown in Fig 1.

Most importantly, graphene transferred by the MET process exhibited outstanding interfacial adhesion with the target substrate as a result of the ultra-conformal contact formation: the mechanical adhesion stability of graphene is maintained even after several cycles of tape detaching tests, as shown in Figure 2g.

It could be confirmed by a contact angle which is measured to be 117° for the honeycomb film before the taping-off procedure, as shown in Figure 4b.

Fasten the leaves adaxial side up, to the inoculation platform using double-sided sticky tape and rubber bands as shown in Fig. 2. Spread the fungal inoculum evenly onto the surface of the bent leaves using a cotton wool swab.