Sentence examples for system values for from inspiring English sources

This section describes the iterative WF optimization, which finds the optimum sub-channels K WF ∗ using the system values for continuous unequal bit loading.

The receivers will operate in a sequence, where the detection is ordered in the descending order of the corresponding system values for the SIC-based systems.

Moreover, the average traffic loads in hybrid network system values for this simulation are around 1%% during intervals, which are due to the initially assigned traffic loads.

When calculating the system values for the SIC scheme, each system value λ k in (11) for k=1,…,K∗ involves one matrix inversion C k − 1, which requires high computational complexity.

The total system values for the cases TG, SIC and MA schemes were calculated by adding the target system values corresponding to the allocated discrete rates b p k for k = 1,..., K.

Discrete bit rate allocation methods based on the use of the mean and the minimum system values for the equal energy and SNR cases were simulated as described in Section 6.

The SNR for the total system value for the SIC scheme is slightly lower than the UB case.

The SNR required for the total system value for the MA scheme is approximately 2 dB higher than the UB case at low SNR values.

The total system value for the case of the SIC scheme, as expected, is observed to be the highest compared with the rest.

This reduced matrix will be used to calculate the system values, and order and remove the spreading sequences with the smallest system value for the next Kopt iteration by setting Kopt=Kopt−1 and repeating the process until Kopt=1.

The system value for the spread spectrum system based on a receiver without the SIC scheme is given by λ k = E k q ¯ k H C − 1 q ¯ k (9).