Sentence examples for system the density from inspiring English sources

With incorporated intercity rail transit into the GIS system, the density of the transportation (R i ) would not change much, while the shortest travel time of each town or street (A i ) would change greatly.

This suggests that, at least in this system, the density of available presynaptic sites is not predictive of how many synaptic connections are formed with the postsynaptic motoneuron.

To evaluate the ability of the different graft types to innervate the host striatum relative to that normally provided by the intact system, the density of the TH+ terminal network was assessed in grafted animals from both groups and compared to TH+ fibre density in the intact and lesioned striatum.

If we apply this density relationship in the SiO2-Al2O3 systhe, the densities of SA1 and SA2 at ambient pressure can be estimated to be 2.24 and 2.40 g/cm3, respectively, which are denser than pure SiO2 glass (2.20 g/cm3) (e.g., Brückner 1970).

After development with the ECL detection kit (Amersham ECL PlusTM Western Blotting Detection System), the densities of each band in the digitized images were measured using the public domain NIH Image programme.

In the both systems, the density asymmetry of the inflowing plasma is about 10.

A crucial point is that whilst single quantum trajectories might not have a steady state, for dissipative systems the density matrix will in general have a steady state which can undergo phase transitions as the dissipative parameters are varied60.

In these systems, the Density of States around the Fermi level is enhanced, giving the composite material the capacity of facile electron transport that may be determinant at the charge/discharge cycling performed in energy storage devices.

However, in the design of composite ballistic protection systems the density of the fiber becomes very important, not just for the weight but also the fiber wave speed to allow the maximum amount of material to be engaged during the impact event, which can last tens of microseconds.

The charge density differences Δρ were obtained by subtraction of the densities of the isolated parts of a system from the density of the corresponding system, that is, Δρ = ρmetal|SAM∥2P − (ρmetal|SAM + ρ2P) and Δρ = ρSAM∥2P − (ρSAM + ρ2P) for the full systems and the pure organic/organic interfaces, respectively.

From the discharge curve measured with the two-electrode system, the energy density (E) and power density (P) were calculated as follows [26]: mathrm{E}=I{displaystyle int}frac{Vdt}{2m} mathrm{P}=frac{E}{varDelta t}.