Sentence examples for system simulation shows from inspiring English sources

The system simulation shows that the detection range is up to 6.7 km for 1 m/s wind velocity error at a wind velocity of 15 m/s with laser energy of 250 mJ and telescope diameter of 406 mm.

Further, system simulation showed that compared to the conventional CO2 HP, the hybrid CO2 HP can reduce electricity consumption by 13.7%.

Real system simulations show the significant improvement (30 200%) in NoCs latency and throughput compared to the state-of-the-art minimum-path approach because of the diminishing hotspots and balanced load distribution.

System simulations show that the proposed controller achieves considerable cost reduction compared to simpler strategies.

A corresponding system simulation study shows that the fixed beam approach is promising especially for outdoor and wide area network deployment [14].

System simulation studies show that the proposed scheme is able to operate fast and accurately for transmission line protection.

When compared to the traditional Incremental Conductance (INC) and Perturbation and Observation (P&O) methods, the system simulation results show the method to be feasible and effective.

If there is a non-power component in fault state, call the distribution system simulation process shown in E and record the indices ( lambda_{k}^{i} ), ( gamma_{k}^{i} ) and ( K_{{ENS_{k}^{i} }} ).

Compared with the traditional uncoded OFDM system, simulation results show the proposed VTR-SISO-OFDM system has at least 1 to 3 dB gain in SNR to achieve the same SER, and the proposed VTR-MB-OFDM system has at least 1 to 4 dB gain in SNR to achieve the same SER.

According to the radar system simulation results shown in Figures 5 and 6, it is easy to observe that 124-length optimized punctured ZCZPS has better performance than P4 code of the same length when the target is not moving very fast in the system.

The pull rod's stress state was determined from in situ strain gages rosettes measurements, and system's simulation showed that the pull rod was designed to support axial loadings only.