The system correction factors were calculated from the middle B-scan and subsequently applied to the other B-scans.
These results confirmed that it is possible to apply the system correction factors obtained from a single B-scan to the whole data set, while maintaining optimal correction.
The analysis derived in sections 3.2 3.3 allowed the determination of system correction factors from a single B-scan of a volumetric data set that subsequently could be applied to all other B-scans.
Because SC mapping works only in the Cartesian coordinate system, the considered machine has to be converted from the polar to the Cartesian coordinate system, and a correction factor has to be applied after calculating the permeance to minimize the error in the permeance values.
For heterogeneous systems, however, correction factors increase with the heterogeneity of the system, and may become quite large.
First, the centrifuge capillary pressures are measured for an oil air system and then scaled for the oil gas system using an interfacial tension (IFT) correction factor.
Harmonization of DTI metrics across manufacturers entailed the use of human-phantom data, acquired multiple times on each of three non-NCANDA participants at each site's MR system, to determine a manufacturer-specific correction factor.
In addition to the ICRS International Cartilage Repair Societyy) scoring system [ 2], lesion area and correction factor for weight bearing have been used in evaluation of the severity of equine articular cartilage injuries in experimental settings [ 1].
Unlike the CAS 200, no tissue correction factor is applied in the ACIS system to correct for underestimation of DI.
