Sentence examples for switching of potential from inspiring English sources

To ensure that the switch from PEG-Epo was independent of a site's participation in the TRANSFORM study, each site was informed of the study and approached for enrollment only after it had been confirmed that switching of potential study subjects was complete at that site.

The voltammograms were recorded using an initiating potential of 0 V with a switching potential of 0.6 V and an end potential of 0 V.

All cyclic voltammograms were performed from a starting potential of 0 V and a switching potential of 0.6 V and an end potential of 0 V and carried out in triplicate.

On the basis of the results obtained in the cyclovoltammetric (cv) and constant potential (cp) synthesis the dependence of that distribution upon monomer concentration, switching potential (Eλ) and potential of synthesis, Esynth, are discussed, the corresponding reaction scheme is given and terms for the reaction rates derived.

For the first test, the triangle waveform FSCV experiment was performed on DA with various scan-rates (from 400 to 1000 V/s) and durations of switching potentials of the triangle waveform (from 0.0 to 6.0 ms) in order to vary the duration between the applied oxidation potential at +0.6 V and the reduction potential at −0.2 V.

The Cs+ adsorbed 3DOM MPiX can be regenerated by simply switching potential of magnetic electrode in a novel electromagnetic coupling regeneration system.

Adenosine poses a specific challenge due to its relatively high E (∼1.30 V), so a switching potential of 1.45 1.50 V is necessary with FSCV.

The limit of detection (LOD) for the triangle waveform is 34 ± 10 nM with a switching potential of 1.35 V and is 21 ± 3 nM with 1.45 V, whereas the LOD is 12 ± 4 nM at the sawhorse waveform with a 1.35 V switching potential (n = 6).

Although larger peak currents are observed at switching potentials of 1.4 and 1.5 V, the signal-to-noise ratio decreased at potentials above 1.3 V.

where Cp is the specific capacitance, m is the mass of the CNFs, ΔE is the potential range, qa and qc are the anodic and cathodic charges during the positive and negative going scan, ia and ic are the anodic and cathodic currents, and E1 and E2 are the switching potentials of the CV.

Different rate trends were obtained with the increase of switching potential.