Sentence examples for sweep results from inspiring English sources
Shooting method and frequency sweep results match for large ranges of frequency.
Next, the frequency sweep results are shown in the spectrogram of Figure 8; the corresponding AGC threshold, the average AGC gain (G AG C, signal field strength, and trace interval are listed in Table 1.
Analysis of the simulation results show that a selective sweep results in a reduction of variation linked to the target of selection, and the extent of such reduction is dependent on the selection coefficient (s) (Figure 3).
The frequency sweep results show the variations of material properties within and between patients.
A selective sweep results in a reduction of nucleotide diversity because linked neutral variants hitchhike with the selected allele (Maynard Smith and Haigh 1974).
Expression prediction was carried out for all parameter sets defined by the parameter sweep (144 GGS runs) and for the parameter sweep results with the two candidate gene sets.
The large sweep resulted in a 27 and 48% greater forward movement than the medium and small sweeps, respectively.
For a weakly selected allele in a population that fluctuates much faster than the duration of the sweep, it will be close to the minimum size encountered during the sweep, resulting in a low effective population size and, correspondingly, a low probability of observing a soft sweep.
The cavity transmission function from Eq. (5) was used, except that either the physical cavity length or the cavity index was allowed to vary over the sweep, resulting in the following expressions for ωFSR: These expressions allow the mode spacing and cavity transmission spectrum to vary as a function of the instantaneous central frequency.
Increasing the number of potential sweeps results in a progressive increase of the current density values of the cathodic peak because of the entry of OH− into the surface layer, which leads to the progressive formation of a thicker NiOOH layer corresponding to the NiO/NiOOH transition [24].
Increasing the number of potential sweeps results in a progressive increase of the current density values of the cathodic peak because of the entry of OH– into the Cu(OH 2 surface layer, which leads to the progressive formation of a thicker CuOOH layer corresponding to the Cu(OH 2/CuOOH transition [46].
