Sentence examples for suspensions solids from inspiring English sources

30 mL batches of goethite (α-FeOOH) suspensions (solids concentrations of 7 g/L; pH 6.0 ± 0.05; 0.01 M NaClO4 (as ionic strength buffer)) containing SDS at various concentrations were prepared and pre-equilibrated for 68 hours on an end-over-end shaker at 25 ± 1°C.

Inter-run accuracy should be performed in situations where there is a complex vehicle (e.g., suspensions, solids and feeds).

For example, using calorimetry allows real-time monitoring of metabolic activity of cells in suspensions, solids, gels, or attached to a surface under oxic or anoxic conditions [ 1, 19, 20].

Figure 4 shows PL spectra of the uncoated (blue curves) and coated (red curves) PSiNPs just after formation of suspensions (solid lines) and after 4 days storage (dashed lines).

These forms are subsequently employed to reconstruct functional relationships between a settling flux function and suspension solids fraction.

General water characteristics measured on-site included pH, salinity (parts per thousand: ppt), temperature, dissolved oxygen and suspension solids.

Three of the fundamental properties which impact centrifuge performance and which are relatively accessible to measurement are the particle size distribution, the suspension solids volume fraction and the suspension rheology.

On-site physical and chemical property measurements of the collected water samples expressed similar pH, salinity and temperature between the two seasons, while dissolved oxygen was higher and suspension solids were fewer in the winter (Table  1).

These changes in key subsystems (i.e. photosynthesis) among seasons were consistent with previous studies by Gilbert et al. [ 9] and our water property measurements showing the greater percent dissolved oxygen and lower suspension solids in the winter (Table  1).

In the Aston Martin DBS, this practically locks the suspension solid.

A suspension solid-state grafting process was applied to graft ferric acetylacetonate onto polypropylene (PP) foams with a density of 0.3 0.7 g/cm3.