Sentence examples for surfaces with a maximum from inspiring English sources

Superhydrophobic surfaces with a maximum WCA of 162° and a minimum rolling angle of 1.0° were further obtained from fluoroalkylsilane modification on the superhydrophilic surfaces.

Probably, Japanese paper, due to the low water content and the short time period of contact with the substratum, extracts salts only from a very thin superficial layer; the data obtained by this method evidence the same salts content on both the two sampled surfaces with a maximum in the central part of the profiles.

An ultra-smooth surface with a maximum peak height (Rp) less the monolayer lubricant film thickness was achieved when the Ar dose was increased to 8 × 1016 ions/cm2.

All thirteen co-seismic interferograms, with different time spans and values of h a (the altitude variation producing a phase change of 2π), reveal a domal uplift of the surface with a maximum displacement of up to ~10 mm in the line-of-sight (LOS) direction although many of them were contaminated.

Similar to Figure 3A, the response surface plot with a constant biomass concentration showed a surface with a maximum stationary point, in which the release of specific protein increased from an initial pulse pressure from 600 bar with number of passes 15 times up to a certain level.

Results show that daily mean DGF surface temperature is significantly lower than the average bare wall surface temperature, with a maximum reduction of 4.67 °C.

Further verification with the fluorescence method revealed surface relaxation with a maximum compressive stress of − 172 MPa induced after LSP within the Al2O3 armour ceramic.

The liquid and gas velocity fields are characterized by a significant non-uniformity with major variation occurring in the region extending up to a distance of two particle diameters from the wall bounding surface and with a maximum located in the high porosity zone.

These were primarily used to target aircraft at heights up to 28750 feet, but could also be used against surface targets, with a maximum range of 16300 yards.

Compared with materials without the addition of any templates, adding glucose during preparation can help materials increase surface area obviously, with a maximum of 198 m2/g for sample M-Glu-0.3.

Irradiation of deaerated CeO2 suspensions in the presence of Ag+ resulted in the rise of a strong surface plasmon resonance band with a maximum at 393 422 nm in the absorption spectra of the solutions, indicating formation of small metallic silver particles.