When done wiping interior glass surface, rinse cloth in warm water and wring again.
Is SAPL the boundary lubricant in prosthetic joints: friction testing and surface rinsing.
Water samples were collected by lowering the bottle at depth of about one foot below the surface, rinsed the bottle three times with the water to be collected before the actual collection of the samples.
1.5, VWR) were rinsed in freshly drawn Milli-Q water, soaked in 3 1 H2SO4 to 30% aqueous H2O2 for 1 h to clean and etch the glass surface, rinsed extensively in Milli-Q water, and dried under a stream of N2 gas.
Use a soft vehicle wash brush, a detailer brush, or a soap dispensing wash brush to physically agitate all surfaces, then rinse dirt and detergent off.
After the incubation, the surfaces were rinsed with 0.1 M acetic acid solution to remove unimmobilized collagen, followed by a DI water rinse (3×).
Surfaces were rinsed in PBS and fixed with 1% paraformaldehyde for 1 h at room temperature.
After removing the culture medium, the surfaces were rinsed three times with PBS.
Surfaces were rinsed three times by adding PBS to the dish, rotating (80 rpm) for 30 s on an orbital shaker, and decanting the rinsate.
After monolayer attachment, the surfaces were rinsed thoroughly with ethanol and dried under the argon stream ready for SWCNT attachment in the next step.
Roots were soaked in 20 mM Na2-EDTA for 15 min to remove metal ions adhering to root surfaces, and rinsed with deionized water several times.
